Material Specifications (WTP)

Matt White Paper, Permanent Adhesive

Product Code: WTP

Label Construction

A typical label consists of 3 components. 

A face material is supported by the liner with special adhesive in the middle

1. Face Material

White wood-free label paper with special characteristics for excellent printability on laser printers and copiers.

2. Adhesive

General purpose permanent acrylic water based adhesive. Good adhesion to a wide variety of substrates, including non-polar surfaces. Good behaviour at low temperatures.

The research centre ISEGA has given the adhesive P1000 approval according to the European requirements for direct contact with dry and moist, non-fatty foodstuffs and compliance with the FDA, 21 CFR Ch.I (April 1, 2013 edition) 175.105 for direct contact with dry foodstuffs or they must be separated from the foodstuffs by a functional barrier.

3. Release Liner / Backing

Bleached Kraft paper, coated on one side and treated on the back.

Uses & Application

Computer labels with good flatness and fan folding with Kraft backing.

Shelf Life

2 years, under storage conditions as defined by FINAT section 2.5 (20-25ºC, 40-50% RH)

Disclaimer

The technical specifications given in this document are general in nature and based on our knowledge, experience and the information and recommendation provided by the material manufacturer, for which reason the suitability of our products for the end use to which they are put cannot be always guaranteed. As our products are used in conditions beyond our control, we cannot assume any liability for damage caused through their use. It is the buyer’s responsibility to assess, test and ensure the suitability of each product for their end use through their own prior approval process; Flexi Labels cannot therefore be held responsible for unsuitable end use of its products. These technical product specifications supersede all previous editions. All information is subject to change without prior notice.

Last Updated April 2024